Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Yes you can reprogrammin using an avr SPI programmer and avrdude or atmelstudio.
depending of the configuration you want to use (i.e internal or external oscillator, frecuency of oscillator, enable disable the reset. etc).
try. https://www.engbedded.com/fusecalc/
Juan.
Hi the " avrdude: Yikes! Invalid device signature.
Double check connections and try again, or use -F to override
this check. "
message say any numbre like Device number is xx xx xx xx must be yy yy yy yy ?
if so then you can check if the wole chips have the same signature.
if the signature...
Mohamed the usbasp and usbtiny programmers have a special function in its firmware , this is when you use the device continuos work fine but if you left in idle state for some time it enter in a sleep state all you need to put to work again is unplug and plug again in the usb port. i have a...
rangerskm maybe you can use drv8811 as stepper drivers they only need 3 pins to control the motor (step, direction and enable) so you can drive more steppers by PIC.
I prefer Atmel Atmega intead of PIcs but is your choice I'm a little rusty in Pics....:wink:
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
