Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
That actually sounds pretty plausible as there's 5 pins. I wish I had one on hand to physically measure.
I've also linked the PDF directlyhttps://www.mouser.com/ds/2/164/ftr-p3-471460.pdf
On some other spec sheets, I see the capitalized version ? which means diameter, but this one has the lowercase one inside the equation for the diameter (arrow pointing to diameter with label that says 5-φ1.5), so I'm unsure as to what the actual dimensions are.
Hey there all, I'm designing a PCB for my job using EagleCAD and came across an issue where the pin sizes weren't properly implemented. The spec sheet says the measurement of the pin is 5-φ1.5 (+0.1/-0). Does this mean the diameter of the pin would be 3.5(+/-) or does φ stand for the Golden...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.