Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi all
I'm new to cadence and would like to find the dynamic range for power detector. What kind of simulation should i use to get the dynamic range?
Attached is the schematic of the power detector.
hi I want to plot the input power vs differential out voltage to find out what's the dynamic range? so what kind of analysis should i run? pss or ac or transient analysis? attached is the schematic of my circuit
if the schematic of my power detector only has one input lets say vin, how can i input 2 signal in namely LO and RF signals at the same point? is it possible to just use the vin or i need to add another input pin?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
