Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Supply voltage is 14V. Voltage to relay (with relay connected) is 12.2. Particular timer I'm using is rated for 200ma, relay draws 150ma. Chip does not over heat. Relay does engage, but never disengages. I will measure with relay disconnected tomorrow.
I'm trying to create an automotive flasher using a 556 timer (only using 2nd half layout was easier using second half, nothing done to any part of first half) Followed the standard schematics and am fairly certain I've got it wired properly. I tried using a 47uf and 22uf Capacitor and varying...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
