Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Could anybody refer me to any good and easy to under stand basics on the design of generators with a high output power. I'm knew to this field and don't really know where to start.
Any help would greatly be appriciated.
Regards
air inductor calculator mm winding
Need to wind an 8.2 uH inductor. The insulated wires I've got, are 0.45mm,
0.5mm, 0.71 and 0.56mm. I've search the web for calculators, but no downloadable "single layer air core calculator' were to be found.
Should I rather wind an inductor with more layers...
DC motor controle ???
Which is the best ways of controlling an DC motors used in Small robots? Are there any online books or documetations on Robotics and the controlling of DC motors?
All help will be apreciated!!!
Regards
I'm new to the world of Oscillators and would like to know what the specification for a 10.245 MHz crystal controlled Colpitts oscillator should be?
Which specification are importend to look at?
I've search a lot of databases for any books, papers, magazines, etc for information but could not...
I've tried the AT41470, AT41486 and BFP420 transistors @ 4.7GHz. In common base they are unstable, but I need to know if it is possible to make these transistors unstable in Common Emitter configuration.
I'm busy researching DRO's using BJT's and would like to learn these techniques/tricks...
I would like to use the CE topology for an DRO Oscillator design but, I just doen't get the topology unstable. I've tried an inductor and later an capacitor in shunt with a resistor at the emitter to ground, to see if I can get K < 1 , |S11| and |S22| >1. I just can't get it to work.
Any...
bfp420
I want to build a 4GHz oscillator using this device. In order to do that i need to simulate the circuit in ADS. This is where my problem lies, ADS does not have the Linear (S-parameter) model available. For those who know about ADS, it is the model that is specified according to its Vce...
Designing a Low Phase Noise Osscillator operating at a frequency of 4.7 GHz.
I'm thinking of using a puck resonator and a transitor in Common Base.
Are there any websites that has examples of how to design such an oscillator or any other type of resources that would help me?
Regards
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
