Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
All
I need to implement a bluetooth chip antenna - probably a HDA. I am also looking at meanderline and monopole antennas. These are all PCB mount and require groundplanes. the GP is not underneath the antenna but is close to on the same side of the PCB.
Some of these require a small PI circuit...
lna s2p file
MA/com does some good LNAs.
S2p usually used for RF analysis.
Doesnt look like hard part to use - pay attention to layout guidelines and part selection
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
