Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
HEllo Everyone
I am also getting same kind of problem and the possible reason, Which I have understood is as follows. The Mode 1 of SMOD serial Communication, frames the bit as 10 bit frame 1 start, 8 data bit and 1 stop bit. bUt the hyper terminal assumes 9 bit frame 8-data bit and 1 stop bit...
You are right sir, but the point is if make SCON as 0x40 (in order to not activate REN) , then also the isr of receive gets activated.
- - - Updated - - -
Now I could figure out that, it was my mistake assuming serial int isr as receive isr , Now that is cleared but please clear me one more...
HI
MCU 89c51, baud rate same 19200
I am facing a problem while serial interfacing of two MCU or one MCU with virtual terminal .
Actually whenever one bit gets transmitted, the receive ISR of MCU gets triggered automatically, but there is no request from other mcu.
Then it never come out also...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.