Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello,
i have created an rectangular microstrip patch antenna (rmpa) with a centre frequency of 2.45GHz.
The Bandwidth @ -10db is 60 MHz but I need 80 - 90 MHz Bandwidth.
Is it possible to increase the length of the patch to increase the bandwidth?
How can I use OPTFEKO for this? What...
Re: 2.4 GHz Patch Antenna
OK, thank you Wim.
So i could use the "inset-fed" antennas, because the matching is created with the help of the inset, is that right?
I want to keep the design as small as possible.
Re: 2.4 GHz Patch Antenna
Actually I will use an own matching network (look at the attached picture).
So I can connect the antenna directly after the matching network?
Hello,
i am looking for an antenna which is working with a ground plane on the bottom side of the substrate (FR4) at 2.4GHz.
It will be placed on "biological objects" like human beeings. What is important for the right antenna in this case?
I found four similar patch antennas:
Circular...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.