Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
OK, I changed my PMOS, and know, added a load, and I always have 0V.
I am quite sure this is obvious...
- - - Updated - - -
OK, got it, I needed to specify a PMOS model.
When using a IRF7210, and a 1ohm load, I get 5A, which is what I am looking for !
Is this circuit OK, or should I add some...
Hi everyone,
My question seems to be posted frequently, but as far as I try, I can't find out my design error...
The goal is to have a temperature driven circuit, using a LM35, a schmitt trigger and nmos+pmos, I would like to let the VCC go or block it.
The simulation below simulates the LM35...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
