Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello FvM and Klaus. Thank you for the replies. The enable signal for my system will be a resistor divider from 12v to give 3.3V at the enable pin so I can bump this up to 3.6V I see the max spec on the ITS part for a logic high is 3.2V. Will consider availability too. When my system powers up...
Hi All, I am looking at using either of the two high side switches for my electronics design. The TPS27SA08 from TI or the ITS428L2 from Infinion. Has anybody used either of these or have any preference to one over the other. My use case is to use a SPST mechanical switch to bring in 3.3V to the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
