Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I'm trying to build an EEG using an ADS1298. This chip was built more for ECG than EEG and is a little too noisy to directly take an EEG signal with, so I'm trying to add some initial gain to get a better noise figure. My question is what is the best way to do this? This is a 24-bit A/D...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
