Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by jjchl

  1. J

    What is the best Linux distro!

    Look www.linuxiso.org, many distros, ready to be burn. Bye
  2. J

    any good microcontroller with lots of flash/ram inside?

    good microcontroller Hi This could help you??? ATmega128/L : 128k flash, 4k EEPROM but only 4k of RAM. hxxp://www.atmel.com/atmel/products/prod199.htm
  3. J

    What is the best Linux distro!

    Linux distro. Please, visit www.debian.org The last version is 3.0r0 (19-july-2002). Bye 8)
  4. J

    muscle stimulator circuit

    Hi, looking for a muscle stimulator circuit. I want to became a muscle man. :lol:
  5. J

    Looking for SmartCard Handbook or similar Books

    Visit this page: **broken link removed** 8)
  6. J

    how to read and write smartcard using microcontroller?

    Hi, look for 'smartcard programmer protel' in www.google.com There are many sites. **broken link removed** 8)
  7. J

    Looking for small CPLD with small number of pins

    cpld isa 9536 I´m looking for a small CPLD, with little number of pins... do you know anyone?? Help me :)
  8. J

    Low cost 433 mhz RX/TX circuit's

    433 mhz circuit Hi, Look this hxxp://www.rentron.com/remote_control/TXLC-434.htm
  9. J

    LEON - does it have been used for actual products now?

    Visit www.opencores.org You can use OpenRISC 1000 too. :D
  10. J

    Looking for pH water meter schematics

    Hello, The PH probe give you an equivalent voltage. You must amplify the signal from the PH probe and compensate it.
  11. J

    Power Supply 0~30V, 0~2A

    design of (0-30)v,2a pwer supplies Hi HARBERT, Please attach the article about PFC Thanks.
  12. J

    Looking information about milling-machines

    Hello can anyone help me. I´m looking about information about milling-machines to made PCB.
See more

Part and Inventory Search

Back
Top