Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
The images that I have attached shows the simulation of microstrip line with physical length 75mm. So as I interpret the S11 parameter plot, can I say that frequencies with lowest S11 value will propagate with minimum reflection. Why are there so many dips? In my simulation the frequency values...
So, should I choose it's length Lambda/4? What about width(not thickness) of dielectric or ground plate? In literature the length and width should be infinite. But for simulations, these have to be finite.
Hello everyone,
I am simply simulating a quasi-TEM mode of a microstrip line in COMSOL. I got the results as expected, but there is one problem that when I change the length of microstrip, the transmission peak frequency shifts. Can anyone comment on this.
Parameters of line:-
Substrate...
Hello everyone,
I am learning 3D fdtd in C. So far, I am successful in eigenfrequency analysis of cylindrical resonant cavity. Now I want to learn MPI based parallelization of the code. Does anyone have some sample codes?
Thanking in anticipation.
Jitendra
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
