Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I read the 2GB SD card in MCB2300 board having LPC2368 controller by keil SD card example. I can see the SD card data in General purpose RAM, but i can't use that data for UART or any other peripheral. When i write instruction of copy that data to UART, disassembly window shows that no assembly...
You complete your project with MCB2300 board in which you read and write text file.
I try with LPC2368 MCB2300 board for SD card read with keil example but i got every time CARD_UNKNOWN so please help me in reading card code.
I read UM10211 manual chap 20 for SD card interface, but it not give...
I am doing project of read file from SD card using MCB2300. I read NXP mannual um10211 but till now i don't understand flow for read file from card. I want extra material for this so anyone have material regarding for this then please give link. Advance thanks for cooperate.
thank you for your good co-operation. I made program for I2S master transmitter and Slave receiver. Now I want to know that in transmitter program after for loop of character transmission i have to put long delay before make stop bit-1. Without delay transmitter not send any character. So why...
Is LPC2368 MCB2300 keil evaluation board support I2S or not? If it support then why keil have no popup window for only this interface? I have code but how can I check that is running or not? I am not able to configure without seeing all register status in popup window. Please suggest me.
Thanking for support, i run this code in keil and get 0 error.
But i want to know the flow (algorithm) to transfer data from one LPC2368 kit to another LPC2368 kit.
I am new to Inter IC Sound (I2S). I have to configure I2S on LPC2368 kit and transfer data between two kits. I read the UM10211 kit mannual for I2S but it is very less for start programming. So please help me or give other material for this. thanks in advance for cooperate.
Hi frends,
I am trying to use auto flow control in UART using RTS-CTS with two keil board MCB2300.
I use UM10211 LPC23XX user mannua for programming. In receiver RDA and RTS both are working and show status in keil pop up window but i am not get change on RTS pin voltage and board DB9 connector...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
