Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I have a question:
I want to switch a negative powersupply (on and off).
I have a controller (open drain,pull-up outputs).
This was my idea: (I wont work because the current cant flow through the fet)
**broken link removed**
DRC error Orcad Capture
This is how I have made my connection (only look at the horizontal connections):
On page1:
**broken link removed**
On page2:
**broken link removed**
If I look at the DRC it sais this:
When I look at the nets I see this:
**broken link removed**
Why does the nets...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
