Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Recent content by jgarciarivera

  1. J

    What are active inductors?

    Re: Active Inductors Try looking this book: Design of Active RC circuits Author: Leonard T. Bruton (this book is out of print though) Presents extensively about Immitance Converters. Also, look on IEEE Xplore for R. Senani. He has been working with these for a long time.
  2. J

    One question is about CMFB in folded-cascode OPAMP.

    Hello, All amplifiers with a high impedance output require a common-mode feedback to control the common-mode output voltage. I simulated my amplifier using AMI mosis models and specifically one simulation corner (I mean, ff,ss) my amplifier failed to amplify. Then I used a Complementary...
  3. J

    how can i figure out the bias voltage for the folded cascode

    Re: how can i figure out the bias voltage for the folded cas This is a file with some biasing tips of the folded cascode.
  4. J

    need help in folded cascode design

    Here is a file with some tips on folded cascode design.
  5. J

    Capacitor Free Low Dropout regulator

    This is a file I found on EDN regarding regulators without output capacitors. Check this.
  6. J

    Do we have to use external capacitor at the output of voltage regulator?

    Re: PSRR for regulator Here is a file from EDN presenting a LDO without output capacitor
  7. J

    help, how to simulate following spec of differential op

    I'm sending you my thesis. A whole chapter is presented on simulations. Otherwise, visit this link: **broken link removed**
  8. J

    help, how to simulate following spec of differential op

    I'm sending you my thesis. A whole chapter is presented on simulations. Otherwise, visit this link: **broken link removed**
  9. J

    how would i decrease the frequency?

    The choices mentioned are good. Either used a frequency divider realized with J-K flip-flops or change the capacitor value of your oscillator.

Part and Inventory Search

Back
Top