Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
the pic show how i connect my thermocouple to the AD595 thermocouple amplifier where purple wire is to connect my power supply and yellow and white wire is connect to my multimeter, but i found that i only get 5.4mV in ambient temperature and get 200mV when i use finger to press the tip, but if...
the picture below are my connection of my thermocouple amplifier, why i only get 5.4mV when it is in ambient temp ? it suppose to take around 200mV? if i use lighter to heat it also remain 5.4mV, my connection is it got problem? i using AD595 thermocouple amplifier and connect accoding the data...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
