Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
Can anybody told me the defination of cascaded filters and ladder filters. What is the difference between them. is there any documents that dicussed about them.
Thanks very much.
model frequency dependent capacitors
Yes.
But I cannot use the "freq" variable in the expression. I want to do frequecy sweep, how can I use the "freq" in the expression?
frequency dependent capacitor
I need a frequency dependent capacitor in the simulation. But I cannot find a capacitor modle in the ADS. How can I realize it? Thank you.
Hi
I have tried to disable mesh reduction and get a much more dense mesh, and this time the currents' show is more reasonable.
Heejing, your method is good,and make the currents more clear.
Thank you, my friends.
Hi,
Recently, I tried to import my momentum proj to CSTMS. In my opinion ,the momentum use a horizontal infinity boundary condition in the simulation. But when the proj was imported to CSTMS, it was shown that there is a box with four perpendicular walls which are perfect E around the struture...
In fact, the current arrows show the same results, the current is very little at most of the area of the spiral (small blue arrows) and some discrete strong currents ( Big red arrows) were found at several points along the spiral. It is very weird.
momentum post process
Hi,
When I use the post-processing visualizaton to check the current ditribution of a spiral inductor. The figure only show several discreted highlight triangles along the trace. But for another spiral inductor which is litter bigger it can clearly show the coutinuous...
Hi,
Does anybody know if the eddy currents will be caculated in the momentum?
If yes, how can I check the currents in post-processing visualization? Thank you.
ads s-parameter simulation
Thank you all.
I suppose there are some tools or functions in ADS could turn the components' S-parameters to conponent value and Q.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
