Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
no drc & lvs errors
i am asking this method is correct r not?
---------- Post added at 10:09 ---------- Previous post was at 10:07 ----------
what kind of drc errors ?
can u explain to me?
what i am done know...
i observed from schematic
i need to matching fingering transistor...
dont mind it W & L
the transister having 4 fingers i need 2 * 2 fingers
so i just select the transister and press q and changed into 2 finguers ..
then again i copied 2 finger transister (means...
what i am done know...
i observed from schematic
i need to matching fingering transistor...
dont mind it W & L
the transister having 4 fingers i need 2 * 2 fingers
so i just select the transister and press q and changed into 2 finguers ..
then again i copied 2 finger transister (means...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.