Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thank you for your quick reply!
The first two cases are not relevant, and the the third give me this message: «Access violation at address 1C8472E2 in module 'ADVPCB.DLL'. Read of address 00000000 at 1C8472E2.» In fact, I had to deal with this message since I encountered the problem. I've tried...
Hello,
Please help me to solve this issue in PCB files: I cannot select any component on the board. I can only select the primitives (polygons, tracks, etc). In fact, it's like Altium doesn't recognize components' bodies anymore.
Re: please help me to design in @ltium
Hi,
Please tell me how to remove pads from GBS and GTS layers.
The goal is to create viases that look like a common hole. No solder mask over them.
Many thanks!
Re: [Help me] About @ltium Designer
Hi,
I need your advice regarding clearance violations in ADW09.
I can't manage with those resistors placed on bottom and top layer. Also that IC's clearance violation give me headache.
Many thanks!
Re: please help me to design in @ltium
The help files of AD are just fine. Also you can take into consideration the training videos from the AD's web page
https://www.altium.com/Community/TRAININGcenter/TrainingVideos/#
keep out area altium
Hi,
My goal is to design a board with metallized pads like these ones
But I'm confused about the correct settings in ADS08, concerning the pad shape. Any help, please.
3d models in altium
Thank you for the reply.
That's my problem. My PC does not support DirectX 9.0c and Shader Level 3, so "3" and "2" shortcuts have no effect. My only chance to reveal the results is to use Lagacy tools> Legacy 3D view in PCB editor, after passing the steps that you described...
how to import dwg file into altium
Many thanks, House_Cat
Because I have no experience of using gerbers files ans industrial pcb manufacturing, I need your advice, please.
This image represents the normal view in the generated bottom overlay gerber data? I mean the mirror comment is ok?
Can...
delete keep out layer altium
Once again I need your help, because I have to generate gerber files from a pcb project. So, my pcb looks like this:
- components are on both sides: THT on top layer and some SMD on bottom layer;
- the copper trace is only on bottom layer (single side).
In this...
PCB inductor
I want to design the structure below.
The problem is that first I have to simulate (in a 3D software) the trace marked in picture for reaching the right inductance. Any help, please!
The inductance of that trace must be around 500nH.
Many thanks!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
