Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
dear pfd please read the question carefully and then reply. i cant change the supply voltage. if u have some sensible answer please send that.
Added after 59 seconds:
dear bbqsky wht is charge pump and how can it be used
hi
i have to make a circuit so that i can change 0-5 volts input to -10 to 10 volts output range. but i have the supply of only 0-5 volts restricted.
please help me out
how to do this?
thnx
cypress microcontroller
hi
i want to design a project on cypress microcontroller "CY8C26443" USING C LANGUAGE .which complier for c do i need for this and also which complier for assembly langauage do i need for this.does it take same instruction in assembly language as that of 8051?
please...
after i shift the output to 0.0-4.6V, will that make the output linear. let me explain what i'm trying to say, with an example, i know i get 0.3volts for 20kPa (sensor standard value) and now if i get a voltage = 1.575 volts and solve it as pressure = (20/0.3)*1.575=105kPa, but instead the...
thanks for replying but in your first solution thru opamp wht should be the value of the resistances to convert 0.3-4.9V to 0.0-4.6V and the second opamp signal by 1.087 to produce the required 0-5V output ..
thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
