Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi
Thank you for your input, I am looking at the microchip design circuit so will I use the 4051 on both sides of the coil? Or should it be used somewhere else in the circuit?
Thank you
Hi
OK maybe a little explaination of what I am trying to do.
I have 4 coils going small to large and all in a center on top of each other.
Now I take a PUK and out a rfid in in, I slide the puk on top a table to circles.
Now I can scan each cicrle to see where the puk landed.
Hope this helps...
Hi
I have having a problem designing an rfid receiver that can read from 4 antenais that can be controlled from the micro at any given time. Let me explain, I need to have 4 coils that can be switched to 1 rfid reader or circuit. I have found some circuit from microhip but nothing on switching...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
