Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I am using linux on a MPC5200 board.
There is a serial interrupt in the code. On accessing a global floating point variable from inside the interrupts I am corrupting variables elsewhere. Is accessing float variables inside not recommended and why ?
also note that the frequency of this...
LMK04000 is a programmable PLL from national. I has 16 registers tht have to be configured. Programming the PLL is through SPI. now these registers are all 32 bit and all 32 bits have to be send together. Is it possible using a 8 bit microcontroller with inbuilt spi to send data to the PLL ?
Re: Power switch problem
capacitors however large are not working!!
edited : capacitors are helping.. the moron in me was trying to include capacitors after the switch which was not working..
the switch is working.. thanks guys...
Power switch problem
dear all
I am designing a 7.4 V/2Ah lithium polymer battery operated device. The power switch (single pole single throw) is in series with between the battery. On turning on the device abruptly the device rarely turns on, If the switch is slowly turned on, it powers on...
teltonika tm1 module
I am using a GPRS TM1 module from teltonika
I am able to establish connections with remote servers with one service provider, but not the other.
Seems like vodafones using proxy servers to connect.
How do I enable proxy server on a GPRS modem ?
Re: PA 13.56
i guess i should have not said the reason why I needed help!!
he wasn't fired anyways, it was some old time grudge.. if that can help me complete this....
Re: PA 13.56
ye
it was supposed to be a 1/2 watt amplifier for 13.56 MHz.
the supply was to be 7.2 volts.
this amplifier was to drive the ISO 15693 signals from S6700 tranceiver ic from TI.
I am trying to complete a design started by my RF engineer, who to show his unhappiness with the management revealed little about the project.
I am not an rf engineer though i know some analog electronics.
his power amplifier was something like the attachment,
can someone help me complete it...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.