Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Motorola DSP5685X and MC56F83XX (FLASH memory but no codec interface). RAD (Rapid Application Development) Processor Expert software.
Microchip Flash based DsPIC family. Some have I2S and AC97 interfaces.
There is a line of National Semiconductor LM50XX 100V PWM controllers. There are very cheap evaluation boards:
**broken link removed**
**broken link removed**
More you can find at National Semi website.
Re: dspic for vector control
Look at AN908 - Using the dsPIC30F for Vector Control of an ACIM
https://ww1.microchip.com/downloads/en/AppNotes/00908a.pdf
You can use Motorola (Freescale now) MC68HC908QT1. 8 pin, 5 I/O + input only. Metrowerks C compiler free up to 4k. $0.70 @1k.
**broken link removed**
Microchip will soon launch 6 pin PIC10F20X in SOT23 case!!!
Re: Can Bus question
If you want to communicate through AC line you had better use ST7538 from ST Micro. It is dedicated for such purposes. CAN over AC line seems to be impossible.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
