Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi Rame,,
In PCB manufacture, we don't say trace thickness, we always say copper thickness.
Trace thickness=copper thickness, 1oz is most customers choice, if the boards isn't power PCB.
Hope it can help you.
Jane Soong
Hi daxkerjames,
I am not sure I correct answer your questions, but you can see below picture, I think you want the ground layer like this? and Isolated connection from pin.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.