Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I see smps and current limiting is a time consuming option, also not very common and less easy to install than i thought. Also not very fool proof what makes selling the rv later on an issue becouse i don't want to electrocute the new buyer aswell as myself.
On my phone it is not very easy to...
Sometimes the advertisements on ali show a perfect product but then in real life it can be a different experience.
Do you know where i can find a good current limiter?
I did try out its 1200watt little brother and that one had the same potmeters to adjust the va's. I measured 5a steady output at 65vcc and turned it down to 3,5 amps to limit the input amps even more. But somehow after a while it started to hickup and go on and off every 5 seconds. Then i...
Hi,
The rv alternator Imax is 120A, a 5A limitation on the SMPS OUT will draw 30A on SMPS IN I think it is better to leave some room for the alternator to also charge the 12v start battery and feeding the accessories.
Meanwhile i found this dc stepup (1800watt version)...
A Friend of mine gave me a 3000watt 230VAC (Growatt SPF3000) island inverter with a lion 4kwh battery. I mounted this set into my rv.
This inverter has 2 mppt inputs. To one of these inputs i connected 4pc 420wp solar panels
and on the other input i try to connect the rv's alternator who can...
Thanks for your reply
I read a little confusion so let me try to clear this out by a short background story (please don't mind my english becouse i am dutch)
A Friend of mine gave me a 3000watt 230VAC (Growatt SPF3000) island inverter with a lion 4kwh battery. I mounted this set into my rv...
I am looking for a ready to buy module
+/- becouse it would be nice to fine tune it
1800watts to let the mosfets breathe a little, becouse the "standard" products have the mosfets rated at only 15amps. But see it more as a preference instead of a requirement.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
