Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i ll prefer for ORCAD 9.2 .. for 32- bit processor.. very good and industrialized .
ORCAD 16.2 is advanced version. free demo available on net
try it , any problem than post thread .
https://www.orcad.com/resources/orcad-downloads
hope this may help you.
regards..
yes sir i am agree with you , that its hard to pack when maximum limit is over.
i am also searching for some data compression technology..
please suggest something useful.
i have a dough regarding CAN bus , what will happen if in a can network if one node is trying to acess it's own id than what kind of error will found ?
hi,
i am working on can protocol. in specification of CAN2.0b it is mentioned for not used same id to two different node why?
what kind of error will be arises if i ll do so?
please guide me.
thank you in adv.
sir i am asking about memory management in mcu .
sir i have to store some data in eeprom of mcu but that data is more than eeprom storage capacity. so i am stack here , i cant found any idea how i use memory smartly.
please suggest me a way.
thank you..
hi sundar
i have not worked with lpc 2148 till now. but i think u should go through application not be the.pdf of this device. may be that will help you out.
for detail...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
