Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi. I'm trying to use an MOC3021 opto triac to control small load Rload =100 ohm , and Vin about = 6->12VAC, so can i drive the load directly ? , i have read datasheet note :"This optoisolator should not be used to drive a load directly"
Another question :
Both of schematic i use MCU,zero...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
