Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I am trying to find sample rate using Nokia Development which is Qt. This sample rate is 2KHz and i'm trying via LAN. I have tried LAN application, does anyone have tried using sample rate with Nokia Development? Coz i don't know what component do i need to use this sample rate. Is it...
I am trying to find sample rate using Nokia Development which is Qt. This sample rate is 2KHz and i'm trying via LAN. I have tried LAN application, does anyone have tried using sample rate with Nokia Development. Thank you.
i want to know what do you usually embedded use for microphone array, could you give me some information for me.
- - - Updated - - -
And also estimate prize for microphone array?
Dear kmwing,
If do you want to learn IP Networking you need to learn basic cable,then OSI Layer after that read lecturer more about subnetting, Routing by download CCNA or take CCNA Course
i was wondering how do you boot with picocom with my device, i have turned out that the serial or terminal in picocom doesn't ready? i wonder what is wrong in my device?
I want to install booting linux,android or wince with sd card in mini2440. Anyone have experience? ihave tried with miin6410 it is ok but with mini2440 it can't boot when it is NOR.
Yes i'm trying serial port programming in linux, i have read some posting here mention dev/tty. I'm still don't understand what this mean and how do you know com1 in linux? could you give me some briefly information how do you know ports in linux like com1,com2,etc. thanks.
I am new with port serial. Do i need to learn port serial in windows first than linux platform? Because I'm trying to program with port serial in virtual linux
to connect mini 2440 you could install linux with virtual linux to install Qt and library Qt in linux. for mini 2440 you'll need the nand flash linux to download to the hardware,then install bootloader(supervivi),linux kernel and so on. Hope you'll get along. you can read in this forum as it...
well,i have check in directory include there is no delay. How do you make this delay. thanks.
- - - Updated - - -
or could you give some easy script to run in my microchip to run on my led or make led blinking, then i'll try to make new one. Thanks.
yes i am using MPLAB C32, this is my script :
#include <p32xxxx.h>
void main()
{
TRISB = 0 ; // set PORTB as OUTPUT
for(;;) // forever
{
LATB = 0xff ; // turn all LEDs ON
Delay_ms(500) ; //...
This is the requirement for Qt application on linux :
**broken link removed**
Well i'm using with Virtual Linux and my Qt install there.
To run this application, you need to click Application> Qt Creator. After the application runs, Qt application runs...
firstly,you click new file or...
i have tried changing my program above from :
void main()
{
TRISB = 0 ; // set PORTB as OUTPUT
for(;;) // forever
{
LATB = 0xff ; // turn all LEDs ON
Delay_ms(500) ; // wait 500 ms
LATB = 0 ; // turn all LEDs OFF
Delay_ms(500) ; // wait 500 ms
}
}
it doesn't work as you acquire.
What do you use qt application in your case? I am using with Qt Creator to make Qt application.
This link knows you how to make Qt Application in Linux OS.
I hope it helps
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
