Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: clap switch
thank you..
as u said i have check it out, and my connection is correct..
through multimeter, i got to know that from IC1 pin 3 there is an output to pin4&8, but there is no output from IC2 pin3, and i have also changed the Transistor(2) and all of the IC...
but the result is...
I have done the clap switch project but the project was a failure, i could not trace out the problems because i have solder all the components following by the provided diagram (see attachment),
can anyone please help me...!!!
thank you.
Additional information.
when the 9V battery is plug...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
