Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thanks again.
My idea setting it to λ/2 was to try to make it look like an open circuit for each other frequencies, isn't that possible? I think I'll follow your advice with the diplexer so I'll appreciatte if you can send me the papers or the links to the papers.
Why is better two resistors...
Hi RF-OM, thanks for your answer.
What I want to do is to make one PCB which sometimes will have a Zigbee (2.4 GHz) module and sometimes a GPS (1.575 Ghz) module, but I would like to have just one SMA, so the device case won't vary.
Maybe is not a power splitter what I'm looking for, I was...
microstrip power combiners wiki
Hi everyone,
I'm interested in designing a microstrip power combiner to connect two modules to one antenna (only one module will be connected at a time). The idea is to have just one antenna connector on the PCB regardless the module I'm using at the moment...
gerber apertures
Thanks for you reply FvM.
The problem as I understand, is exactly when Eagle is generating the aperture configuration file. I was reading around and maybe it could be some "figure" on the PCB that is causing that? but if it is, I don't know how to determine which one is the...
aperture gerber
Hello everyone, my name es Victor and I'm from Venezuela. I just registered in the forum. :D
I'm writing you beacuse I'm trying to generate the gerber files using Cadsoft Eagle 4.16r2 and the "GERBER" device, but it keeps saying "APERTURES MISSING - NO PLOTFILE HAS BEEN...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
