Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi
I like to listen to a station 1000 Miles away on 1190KHz at night. I use a tuneable multi turn magnetic loop antenna that is passively coupled to the ferrite rod in the radio to pull in the station, it works well.
But there is a station at 1200KHz on nearly the same vector that bleeds over...
i googled, repair Flash drive capacity, see if one of these links help.
Repair a flash drive that isnt displaying full capacity
How to fix USB flash drive with low-level format
Format USB Flash Drive’s Showing the Wrong Capacity the Easy Way
Ok
I found bulb for 6V lantern so its actually 4.8V 300mA, it charged batteries all the way up and nothing got too warm, bulb is a little dim at all times, at full volume bulb brightens a bit when theres a loud noise like when WWV hits top of the minute.
Looks good to me........
Ok thanks.
Capacitor was near the front end of receiver, I thot a 103 would work didnt have one, tried a 104 it worked but reception was a bit weak, so tried 102 and reception was normal.
Hi
When i was fixing my radio I had to replace SMD capacitor with a ceramic disk capacitor.
The SMD capacitor was dark brown, some others were light brown, some were white.
Is there a color code for their value?
:?:
I would buy a cheap 60W pencil iron, that way if it dies someday you havnt lost much, one that has a high/low switch helps keep the tip from eroding away. As soon as its hot wipe tip on a damp rag that cleans it nice. When your done tap it sharply on something to knock off excess solder.
To...
Re: Question about a PCB
Try sanding it with 120 grit sandpaper if that works then use 180 or 220 grit so it does not make scratch marks.
Try acetone on the printing that will take the ink off, but watch the acetone dont eat the board.
SEO is done make a site show up nearer to the top of search engine results.
If you are a baker and someone searches for bread and gets 1000 pages of results and your bakery site is on the 800th page SEO can help get your site closer to the first page.
Hi
I really like Edaboard, it has features most forums dont have that make it enjoyable.
:smile:
However I find it logs me out too soon.
Is there a way to stay logged in longer?
:?:
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
