Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by iliyana

  1. I

    ESD resistor question

    Re: dog bone resistor picture Poly resistor is easy to fab..where most of ESD was designed with the poly resistor. But I'm more interested on ESD which is designed without the poly resistor & said that it is better than the ESD with poly resistor in terms of the switching. Can anyone explain...
  2. I

    Power Mosfet design rule setting

    Hi, Currently i'm doing some study on the design rule setting for the power mosfet (0.25um & 0.18u technology). I would like to know, basically for 0.18um technology what is the standard ACT photo ADI CD & AEI CD would be? Should we set the ADI CD = 0.18um or AEI CD= 0.18um??? Kindly advise.
  3. I

    Dual implant processs - which one will come first

    Re: Dual implant thanks for the opinions ya, i'm thinking of doing the TCAD simulation for this n also to run the energy sequence evaluation, then measure the Rs & see if there's any difference or not.
  4. I

    Dual implant processs - which one will come first

    Dual implant Hi all, I need some advises from the mosfet expert. I would like to know on the sequence of the energy for the dual implant process. Which one will come first, low energy / high energy? What is the main concern/ effect if the sequence is not correct? Thanks in advance.
See more

Part and Inventory Search

Back
Top