Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
As an update played with the scope and can now get both channels to work and can see the calibration square wave. However, the trace is unusably dim. So I am pretty sure its the EHT supply. This is the only circuit diagram i can find https://www.edaboard.com/attachments/hv_section-gif.63458/...
The only way I can see the spot is by turning down the room lights.
Turning the intensity potentiometer reduces the spot intensity, in fact a slight turn of the dial and the spot is gone.
The spot can be moved using the vertical and horizontal adjust
I tried different sweep speeds and once I...
Hi I have a Tenma oscilloscope that was working fine, than after not using for a few months all i could find was a very dim spot that disappears as soon as I switched on the time-base. I tried following this thread https://www.edaboard.com/threads/oscilloscope-tenma-72-6800-no-trace.228452/ ...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.