Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
back view of lm317
LM317/LM117 they basically the same thing
no load
10Vp-p
40Mhz
what is 2 channel CRO?
Ive tried to input a sawtooth waveform basically having the same frequency and amplitude the output was fine works fine without unwanted oscillation at all.
Hello
Im having problems using the LM317 current limiter configuration. Im tryin to input a squarewave (fig a) and im assuming that a squarewave (fig b) should be the output having the same amplitude and frequency, provided that i don't exceed the current limit that Ive set for the LM317...
lm324 generator
yes, the input sawtooth is correct
Power supply = 15V
Input sawtooth DC average by this do u mean the voltage of the sawtooth goin into the amplifier? then it is 8.14V
op amp sawtooth
actually it starts out as a perfect tipped sawtooth waveform. Ive put a variable resistor on the non-inverting amp ckt so i can adjust it both on the R2 and R1. As soon i adjust the potentiometer it clips at it reaches the 9.++volts mark
**broken link removed**
comparator sawtooth generator
Hi
Ive been using a non-inverting amplifier to reach 10Volts but when i use a DMM it reads 10V but when i look at it on a Oscilloscope the sawtooth is being clipped. what is the reason for the sawtooth being clipped? Im using a differnt IC(IC2) another LM324 w/ a...
sawtooth generator
Hello everyone,
Im using this ckt, its basically a sawtooth generator using a LM324. It works okay. my problem is that the ckt doesn't oscillate when i input 5,4,3,2,1 volts but its fine @ 6volts up to 15V. @ 5,4,3,2,1volts the ckt outs a DC voltage. Ive tried to use...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.