Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
brushless driver module
u can save on 3 phase gate driver IC (International Rectifier do provide that).
but to have a module of the 3 phase power mosfet is quite expensive.
bldc inverter
i'm designing a 3 phase inverter circuit.
it will be applied on 3 phase BLDC motor (AC300020_PB.pdf).
my current inverter circuit i'm designing (inverter_ver1_1.pdf) is able to run the motor but only in very slow speed rotation. For switching frequency 100Hz to 400 Hz the rpm is...
using ir2130 for brushless dc motor
I'm designing a 3 phase inverter to drive a Brushless DC motor.
I'm using IR2130 for the MOSFET's (IRF840) gate driver.
Current configuration that have been made not given me any good result.
I have tried 10uF as bootstrap capacitor and IN4001 for the...
yup, in my point of view, it is proper for you to start with C 1st, then migrate to C++ and C#. don't worry.. once you can understand the concept very well, c++ is not a big problem to you.
~ it s works very well on me :D
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
