Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: USB interface
thanks for the reply.right now i am not having a memory interface.just testing out
the camera.i was trying to make this gui.however i would like some guidance on
the driver building.is the driver required at all.as you said maybe if i have a
memory interface i may be able...
Hello,
I want to access data from a camera through usb.I do not have a driver for the usb.However i've downloaded a software called thesycon which made the driver for me.however this application is a not free.Is there any freeware for making drivers ? Also can i make a Gui which would access the...
Hello,
I wish to connect some 8 antennas to a single receiver.My receiver is an embedded SOC which is low power.I wish to switch between these antennas at specific point of time.Is there any small switch which is low power which I can use to switch between these antennas ?
Kindly help me as to how to route the pcb containing the helical antenna.The transceiver chip has multiple pins for analog and digital as well as separate pins for avdd and dvdd
Thanks. I have one more constraint however.My antenna has to be integrated on a pcb along with the tranceiver chip.The ground plane has to be one of the layers of the pcb,i guess.Will it be possible to make the pcb as small as possible?.Are there any good software for modeling the helix
Thanks for your replies.
However I have a severe area constraint for the ground plane.Also is it possible to
reduce the size of the helix considerably to about 6 turns and get 433MHz performance of 10 db or nearby.
Are there any design equations for helix
rgds
helical antenna design equations
Hello,
I am trying to integrate a helical antenna into a communication system.My system consists of a Tranceiver from TI which gives an output of 10 db. The helical antenna(single feed) has bandwidth in the ISM band 433 MHz.The antenna has 24.5 turns,1.428 mm...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
