Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
So grateful for your help and input. It will be a little while before I can give more feedback and do more testing as I have burned through my latest order of MOSFETS. In about a week I will be ordering a MOSFET board from IXYS that will hopefully give me more reliability in my testing.
The MOSFET is switching fine as I have driven other simpler/smaller coils with this setup without a problem. I am driving it with square waves at 10V. One correction to my original post: My supply is 20V DC.
I am connecting one input of the pulse transformer input to 20V DC and the other input...
Lads/Gents:
I have a pulse transformer that can't seem to get output on. It is designed for 12 volt DC input and 1000 Volt DC bi-polar output. I am attempting to drive it with 12 volts /10 AMPS DC via a 60V 30A Mosfet. The coil sits between positive rail and Drain of Mosfet.
Thanks,
Mark
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
