Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I am trying to use one ultrasonic transducer for RX and TX. The transmitted signal was 25 KHz square wave from Arduino Uno, and the switch is controlled by Arduino. The result is shown as the following picture.
The four cycles of square wave is the transmitted signal and after that it is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
