Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi, I am using Allegro PCB editor 16.3.
during the process of board layout, I found some error in one footprint and modified it.
How can I update the change to my .brd file？ I tried ECO in Capture CIS but it didn't work
for footprints update. Thank you!
Hi, I got a problem when creating a footprint symbol for a 64pin connector using Allegro PCB editor 16.3.
The default page size is about 800*800mil, but my connector is 36mm*6mm, which far exceeds the page size.
I tried but still can't figure out how to change the page size. Anyone can tell me...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
