Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I don't understand how does single balanced mixer cancel RF to IF feed through , and also how does double balanced mixer cancel LO to IF feed through ?
Thanks alot .
I have another question .... I am working on TDC and I want input signal which is (LOW) and after few seconds becomes (HIGH) then still (HIgh), How can I get this on cadence ?
which gm rule can I use in design of simple mosfet amplifier circuit ?
after designing such circuit and thus obtaining values of Id , W/l and Vod , should three rules of gm be equal or not ?
gm rules I mean:
gm=Un*Cox*W/l*Vod
gm=2Id/Vod
gm=sqrt(2Id*Un*Cox*W/l)
Hi , I tried to design common source amplifier by hand analysis and obtained certain values of circuit parameter , then put these parameters into cadence simulator , after simulation I noticed that there is a big difference between the results obtained from hand analysis and others obtained from...
Hello everybody ,why do we perform DC and AC analysis in mosfet amplifier ,is the voltage gain equal to the ac output voltage over the ac input voltage or the resultant of DC and AC voltages, and finally is Id the DC drain current or ac drain current such in this equation Id=.5 Kn*(Vov)^2 ?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
