Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by honey361

  1. H

    Please check the Buil fail error in MPLAB IDE V8.20

    Buil Fail Error Dear Expert, Please check the Buil fail error in MPLAB IDE V8.20
  2. H

    I need pwm according to the encoder 1024 pule speed

    PWM OUT Dear All, Can any one advise the below code where is wrong because it is not working with encoder, I need pwm according to the encoder 1024 pule speed, maximum encoder shaft speed is 1400 rpm, mcu is AVR Atmega8L amd software is Bascom-Avr, Thanks in Advance $regfile = "m8def.dat"...
  3. H

    Need help to convert Hex File for burn into Micro Controller

    Covert Hex File Dear Experts, Kindly help attached file conert in HEX COde for burn into Micro Controller, Thanks in advance, Asif
  4. H

    Code required for pic, to control a inductive coil by triac

    triac inductive load Hello, Code required for pic, to control a inductive coil by triac Regards honey
  5. H

    How can I convert into Hex following Code

    hexadecimal 64, 128, 256 Dear All, How can I convert into Hex following Code #include <pic.h> #include <string.h> #include <stdio.h> __CONFIG(BORDIS & XT & LVPDIS & PWRTDIS & WDTDIS & WRTEN); #define FOSC 14318180 #define FPWM 20000 unsigned char Fila1[16]; unsigned char Fila2[16]...
  6. H

    Encoder 1024PPR to 0-5v

    1024 ppr Dear All, Can any one advise the below code where is wrong because it is not working with encoder, I need 0-5v according to the encoder 1024 pule speed, maximum encoder shaft speed is 1400 rpm, it should gives out 5v dc at 1400 rpm, mcu is AVR Atmega8L amd software is Bascom-Avr...
See more

Part and Inventory Search

Back
Top