Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
calibre lvs
I run Calibre LVS with these errors
how can l slove it???
ERROR: Corresponding cells could not be identified.
ERROR: Nothing in layout.
*** Calibre finished with Exit Code: 4 ***
#############################################################
##...
this is the error
**error** element 0:iin has been
referenced but not defined
any ideal to solve it ??
Added after 2 minutes:
this is my sp file
*******typical library mode********
.protect
.lib 'c:\hspice work\rf018.l' tt
.unprotect...
I want a dc simulation with Iin , but there are two nodes conneted to Iin.
Iin=-35ua~35ua, I0=20ua, In and Id are the outputs
how can I use dc simulation.
Any ideal ???
thank you!!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.