Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
oh i forgot is 1N4007 is fast enough to charge the bootcap at 150KHz switching speed?? if not then, can any one give me a better suggestion for a fast high power diode?
---------- Post added at 23:17 ---------- Previous post was at 23:16 ----------
ohh thanx..after just posting my reply i...
the intended power is to reach 2KW.
---------- Post added at 21:14 ---------- Previous post was at 21:11 ----------
The intended power is to reach 2KW.
---------- Post added at 21:15 ---------- Previous post was at 21:14 ----------
Surely i'll use 1n4007. thanx for the advice...
Hi,
I was designing a High Power High frequency Induction Heater inverter. I choose H-bridge configuration for the inverter
and IR2110 gate drivers to drive the bridge. As the IR2110 is a half-bridge driver i'll use two of them to drive the both sides.
I've done a rough circuit(just drawing)...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
