Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Recent content by hemantc007

  1. H

    Setting ALL PORTS of PIC16F877A as digital INPUT/OUTPUT in MikroC Pro

    Hello I have some kind of problem using pic16f877a and have lm324 output at RA0 and RA1 and checking them and glowing led until input as 1 #include<htc.h> #include<conio.h> #include<stdio.h> #include <xc.h> // CONFIG //__CONFIG(HS & WDTDIS & PWRTDIS & BORDIS & LVPEN & WRTEN & UNPROTECT &...
  2. H

    [SOLVED] [MOVED] Pic16f877a input sensor problem lm324

    Problem solved ... Converted Analog input of lm324n to digital I used AN0 as input and configured ADC ADCON1=0x87; and it worked. Thank you Regards
  3. H

    [SOLVED] [MOVED] Pic16f877a input sensor problem lm324

    Please Help me with this my project hangs in balance .....PLZ help And also want to is the output of lm324 analog or digital.........plz urgent
  4. H

    [SOLVED] [MOVED] Pic16f877a input sensor problem lm324

    Hello everyone, First of all I am very thankful to this forum for post and great help while reading diff threads. After searching a lot I am posting this thread so as I can get help in solving my problem. mu-pic16f877a using a development board LM324n IC for proximity sensor (checked its...
  5. H

    [SOLVED] 16F873A ,facing problem in proagraming..

    i am using a pic uc 16f877a i downloaded a blinking led in it through a isp programmer verified and read on simulator and when i connect it my simple circuit wherein vdd vss and vpp are accordingly connected to 5v,0v,resistor+5v resp and 8mhz crystal oscillator with two 33pf caps i do not output...
  6. H

    JDM programmer problem?

    Bought a new PIC programmer ICSP and found what I was doing wrong.. It was just one pin , in JDM programmer the 6th pin have to be connected to PGM(pin 36 in pic16f877a) then the error will be resolved . And verify checks if the buffer content and pic content match or not . Hope that will help...
  7. H

    JDM programmer problem?

    please someone reply... what should be done to get the voltage at other terminal to 5v... Please help very urgent stucked at this point.
  8. H

    JDM programmer problem?

    Using the same circuit and having the same problem using ICprogm 1.5a error after check "verify failed at 0000h" my hardware check: mclr : 15v vcc,clk : 2.5v Please someone help its urgent. Thank you.

Part and Inventory Search

Back
Top