Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi to all,
thanks for your valuable work. When I use dividers 6.8K and 100K (0R47-100K for amp) ; in proteus volt-amp readings come as 66.16 and 28.38 respectively (same thing happens on the real circuitry). To calibrate the voltage i used 100k multiturn trim, and got a good result after...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.