Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by harrybeafull

  1. H

    Prof tolls for small service

    http://www.renex.info/pokaz_produkt.php?id=106
  2. H

    which is the best soldering & desoldering stations?

    goot solder stations I recommend PACE - http://www.renex.info/pokaz_kategorie.php?cid=43
  3. H

    How to unsolder or unbraze a silver-soldered joint between stainless steel and brass?

    Re: Remove the soldering http://www.renex.info/pokaz_produkt.php?id=106
  4. H

    Reg:PCB Standards-IPC - are they necessary? What's the cost?

    Re: Reg:PCB Standards-IPC www.renexeec.com
  5. H

    Can any one give me IPC-A-610 standards?

    IPC-A-610 http://www.renexeec.com/pokaz_produkt.php?id=96 http://www.renexeec.com/pokaz_kategorie.php?cid=45 - handbooks
  6. H

    QFN chip mounting - dont have pick and place tool

    Re: QFN mounting http://www.renex.info/pokaz_info.php?id=26
  7. H

    Looking for IPC 2141A and IPC 2252

    IPC 2141A www.ipctraining.pl www.renexeec.com
  8. H

    Reg:PCB Standards-IPC

    ipc standards questions www.ipctraining.pl www.renexeec.com
  9. H

    Where can I get the IPC-2222 ?

    what does ipc-2222 recommend www.ipctraining.pl www.renexeec.com
  10. H

    Can any one give me IPC-A-610 standards?

    Re: IPC-A-610 www.ipctraining.pl www.renexeec.com
  11. H

    Soldering SMT Components

    procedures for smt soldering http://www.renex.info/pokaz_info.php?id=26
  12. H

    Prof tolls for small service

    good or Chinese? is the difference....:D
  13. H

    Low-cost soldering iron

    I found GOOT PX201 soldering iron - http://www.renex.info/pokaz_produkt.php?id=2161
  14. H

    How to mount a QFN chipof 16 pins and the pitch of 0.5mm on a PCB?

    Re: QFN mounting Use solder paste, flux and hotair station - http://www.renex.info/pokaz_kategorie.php?cid=51
  15. H

    Soldering SMT Components

    hobbyist smt soldering equipment techniques http://www.renex.info/pokaz_kategorie.php?cid=43
See more

Part and Inventory Search

Back
Top