Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by Harjinder

  1. H

    Analysis Results in OPNET

    Respected Sir, I am using OPNET 14.5.I want to know that how to analyze the results in OPNET.Can results calculated from it peek loads.Provide me steps that help in analysis of results in OPNET and in getting correct resultant values.I compare three routing protocols on basis of...
  2. H

    Error in opnet modeler

    Hi... Can anyone provide me solution for following error in OPNET Modeler 14.5 From procedure: manet_imep_disp_message (const char* msg0, const char* msg1) Warning from Manet-Tora-Imep process: Unknown interrupt type received, stopping simulation ---- Simulation terminated by process...
  3. H

    ip_dispatch error in OPNET

    Respected Sir, I am using OPNET Modeler 14.5.But when I compile my simulation ip_dispatch error in some nodes.If I fail the particular node the simulation is complied.But it is temporary solution.Again ip_dispatch error message shows.Kindly provide me solution for this in steps.What is cause of...
  4. H

    CBR Traffic is Supported by OPNET

    Respected Sir, I wants to know that OPNET supports CBR(Constant Bit Rate) traffic for routing protocols in mobile ad hoc networks(MANET).Kindly provide me RFC(Request For Comments) for DSR,GRP,TORA routing protocols.
  5. H

    Error in Simulation Process

    Respected Sir, I received a following error message when I run simulation in OPNET Modeler: Network.mobile_node_4.ip), T (124.371), EV(1220806) Error in IP routing process model (ip_dispatch) : Unable to set size of final fragment. Check simulation log messages from the IP model for more...
  6. H

    Run Time Error 6034 In OPNET

    Respected Sir, Kindly provide me a solution for runtime error 6034 in OPNET.This error message appears when I run the simulations.I am using Microsoft Visual Studio 2005 and OPNET Version is 14.0.My operating system is windows 7 ultimate 32 bits.:cry:
  7. H

    Can Network Simulator 2 supports FTP and CBR

    Can anybody help me I want to know that can Network Simulator 2 (NS2) is support to FTP and CBR Traffic Loads.Kindly provide me link from where I download latest version of ns2 for windows with installing instructions and some tautorials on ns2.
See more

Part and Inventory Search

Back
Top