Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
reflectarray measurement
Thats a good point about terminating the box with ground plane but eventually i want to put a slot in the ground plane and computer S21 so i have the model setup that way.
I tried to simulate the structure using square configuration (actual requirement).
I got some...
floquet ports
Dear Ivan
Thank you for your reply.
I have created a model for the reflectarray element.
One: Using parallel plate waveguide to obatin normal incidence
Two: using floquet ports for normal incidence.
I am attaching the file.
please let me know if the confguration is correct as the...
hfss unit cell for triangular lattice
I am trying to calculate reflection phase for patch reflectarray and i want to compute the reflection phase using floquet ports.
I have simulated the reflectarray structure using waveguide simulator approach and already got reflection amplitude and phase.
I...
te 10 mode
I am trying to calculate reflection phase for patch reflectarray and i want to compute the reflection phase using floquet ports.
I have simulated the reflectarray structure using waveguide simulator approach and already got reflection amplitude and phase.
I am trying to use floquet...
Hello everyone
I am trying to plot the radiation efficiency of a patch antenna vs thickness of the substrate. I want to see the effect of dielectric loss, conductor loss and surface waves on the radiation efficiency.
Does anyone know how to calculate surface waves for patch antenna with...
Hi all
i am using HFSS ver 10 and trying to simulate a periodic structure (square metal plate)
This is the design
1. The master slave periodic boundary conditions to make the structure infinite in the XY plane. Unit cell is terminated by PML on top and bottom surfaces. I have taken care that...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
