Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Please tell me 10uf capacitors are fine or not ???? because I notice from max 232 datasheet that 1uf is recommended. Can 1uf use for this purpose???
Yes I correctly choose the baud rate in terminal which is 96000. I have make my pcb design instead of schematic design. I am posting both of...
I automate the trainer at-5000 for my project. I designed the circuit using 8051 (AT89S51) controller that take the input from trainer seven segment and convert to the ASCII characters and display the data in the form of 456, 940 upto 999 via TTL to Max 232 circuit in hyper terminal.
The...
Question no.1
the task is given to me that I have to write detailed note on multi service access gateway(MSAG)
Please any one that give me detail pdf or any book that contain detailed information about multi service access gateway (MSAG)
Question no.2
Also what is difference between...
I have to do FYP in Telecommunication Engineering. I have interest in Wireless communication.
I want to chose the FYP which is
1) Design and Optimization of 1.25/2.50Gbit/s Hybrid Opto-Wireless System for In-flight Cabin Communications.Please tell me about this. Either this has more scope in...
HI,
I am not deciding to choose course from:
1) Optical Fiber Communication.
2) Spread spectrum communication.
Please tell me which is better for my future and has more scope in future.
I am doing BS in Telecommunication Engineering.
Hi, I am difficulty in choosing the subject.
I want to ask this from experts of both subject. I am doing BS in Telecommunication Engineering
I have to choose elective subjects.
Options are:
1) Embedded system
2) VLSI.
Which is better subject either Embedded system or VLSI and has more...
Hi, I am designing "Printed UWB Antenna Operating Over Multiple Mobile Wireless Standards " from IEEE page.
Please help me how to assign lump port for this design.
Is any tutorial for this.
IEEE page is attach. Please check it
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.